Window - Front Door

REMOVAL




1. Remove trim panel.
2. Remove water deflector (carefully peel off).




3. Remove lower rear window run channel by removing bolt and pulling the channel down to unhook it.
4. Run window to down position.




5. Remove inside weatherstrip around front half of window.
6. Run window up to half way.




7. Loosen rear most regulator attachment bolt.




8. Remove window glass by tilting rear of glass upward and sliding up and out.

INSTALLATION




1. Install window glass by tilting rear of glass upward and sliding down and into regulator channel.
2. Move window to the down position.




3. Install inside weatherstrip around window.
4. Run window to complete up position.




5. Install lower window run channel by pushing the channel up to clip it into place, and install bolt.

Torque: 10 N.m (89 in-lbs)

6. Push glass rearward to seat in rear window run channel to bring pressure against rear channel and tighten rear most regulator attachment bolt.

Torque: 10 N.m (89 in-lbs)

IMPORTANT: Replace water deflector if damaged.




7. Install water deflector.
8. Install trim panel.
9. Operate window to up and down position to cheek operation. If binding exists, inspect all weatherstrips and adjust as necessary.