Fuel Pump Module
TOOLS REQUIRED^ J-43827 Lock Ring Remover
REMOVAL
1. Remove fuel tank.
NOTE: Clean all fuel pipe and hose connections and surrounding areas before disassembling to avoid possible contamination of the fuel system. Spray the fuel pump module cam-lock ring tang with penetrating oil prior to attempting removal.
2. Disconnect fuel lines from fuel pump module cover.
NOTE: To prevent retainer damage, do not attempt to remove the retainer with a 12 in. or shorter ratchet/breaker bar.
3. Use the lock ring service tool J43827 and remove the fuel pump module retaining ring. A 1/2 in. breaker bar (approximately 18 inches long) will easily loosen and remove the lock ring.
4. To prevent bending of the sending unit float arm remove the sending unit first by pulling the retaining clip toward float arm and lift upward.
5. Carefully lift fuel pump straight up from fuel tank. To disengage fuel pump from fuel pump housing (4) clips must be disenabled at the same time.
IMPORTANT: Always replace fuel pump module to tank seal (O-ring) whenever assembly is removed.
6. Discard fuel pump module to tank seal.
7. Remove fuel pump housing by releasing retaining Clips. The retaining clips hold fuel pump housing to fuel pump housing bracket (mounted in bottom of tank).
a. Disengage clip closest to the pump (where fuel return line attaches to fuel pump housing) by inserting a small flat-bladed screw driver between the clip (on the housing) and the mounting bracket. Leave screw driver wedged in place to prevent clip from reattaching as the other clips are being disenabled.
b. Disengage the clip closest to the one disengaged in previous step (toward rear of tank). Use a second small flat-bladed screw driver to disenable this clip.
c. Stick one of the screw drivers between the fuel pump housing and base of the fuel tank to prevent clips (previous steps) from re-engaging. Remove second screwdriver from fuel tank.
IMPORTANT: Inspect fuel tank for metal chips/debris. Remove all contaminants and replace in-line fuel filter before installing a new fuel pump assembly when debris is present.
d. The next clip to be disengaged is at the rear most position. To disengage this clip tilt housing toward jet pump while releasing this clip.
e. Once these clips have been disengaged push module (or roll the module) in the direction of the remaining clip that is engaged. This will force clip to disengage.
f. Remove housing from tank.
INSTALLATION
1. Install new fuel pump and housing straight down into fuel pump housing bracket. The jet pump needs to be toward front of tank on drivers side. Make sure all clips engage.
2. Install fuel level sender into fuel pump housing and connect its connector to fuel pump cover.
3. Insert new fuel pump to fuel tank seal.
4. Use lock ring service tool (J 43827) to install fuel pump cover lock ring. (The bumps on the lock ring need to be facing away from the tank.)
5. Install fuel tank pressure sensor and nut.
Torque: 2 N.m (18 in-lbs)
6. Connect fuel lines and wiring harness.
7. Install fuel tank.