P0135
Schematic:
The front oxygen sensors are equipped with heaters to assist in ramping up to the nominal operating temperature of the front oxygen sensors. This decreases the amount of time required to enter closed-loop operation where maximum fuel efficiency is attained. The ECM diagnoses the heater and it's related wiring by continuously monitoring electrical current. The ECM will set this DTC if the O2 sensor does not become active within 20 seconds of the heater reaching 37°C (99°F).
DTC PARAMETERS
This DTC will set when:
^ Battery voltage is not between 11.03 and 15.52 volts
^ Engine is running
^ 20 Seconds have elapsed since heater reached closed-loop temperature.
DTC P0135 is a (type B) DTC
DIAGNOSTIC AIDS
DTC P0135 is a rationale check on the heater circuit of HO2S Bank 1 Sensor 1. This DTC is the result of an inactive sensor 20 seconds after the sensor has reached operating temperature. The ECM will only run this rationale check if the heater circuit has passed the low and high fault circuit tests.
Possible causes:
^ Exhaust leak near HO2S Bank 1 Sensor 1
^ Contaminated sensor or slow sensor
NOTE: If P0134 is also set, a signal circuit problem exists and should be diagnosed first.