56. Camshaft Drive Sprocket Installation

- Tools Required
- J-42069 Alignment Tool Kit


IMPORTANT: Install alignment pin in correct numbered, alignment slot on camshaft gear.





1. Install camshaft gear.





2. Install camshaft gear bolt.

IMPORTANT: Use a new camshaft gear bolt. The required tightening method will stretch to its yield point, therefore, the bolt is not reusable.

- Use relevant J-42069-1 and J-42069-2 Camshaft Gear Locking Tools to hold camshaft gear and camshaft in place while tightening camshaft gear bolt.
- Tighten camshaft gear bolt.
- Torque: 50 Nm (37 ft. lbs.) + 60° + 15°