Tail Lamp: Service and Repair

Tail Lamp Replacement (Wagon)

Removal Procedure






1. Open the tailgate.
2. Remove interior rear access panel.






3. Remove the nuts from the tail lamp.
4. Disconnect the electrical connector from the tail lamp.
5. Remove the tail lamp by pulling straight back.

Installation






1. Connect the electrical connector to the tail lamp.
2. Position the tail lamp to the quarter panel pressing in until fully seated.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the nuts to the tail lamp.

Tighten
Tighten the nuts to 3.5 Nm (31 lb in).






4. Install interior access panel.
5. Close the liftgate.