Control Lever Boot Assembly

REMOVAL





1. Disable SIR system.
2. Remove console.
3. Unclip the boot assembly from the plastic retainer in the rear of the shifter control assembly by pulling rearward and upward on the boot.





4. Unclip the boot assembly from the two plastic retainers in the front of the shifter control assembly and remove the boot.

INSTALLATION
1. Place the boot on the shifter control assembly and clip the two plastic retainers in the front of the shifter control assembly.
2. Clip the boot assembly onto the plastic retainer in the rear of the shifter control assembly.
3. Install console.
4. Enable SIR system.