Flexible Plastic Parts

FLEXIBLE PLASTIC PARTS

Flexible plastic service replacement parts are primed from the factory.

1. Wash the the damaged panel and surrounding areas with water and a mild detergent, rinse thoroughly and let dry.
2. Clean the panel with PPG D837 Acryli-Clean(TM) or equivalent.
3. Repair all damaged areas.
4. Sand the entire panel with 240 grade sandpaper.
5. Clean all sanded areas with PPG D846 Multi-Prep or equivalent to remove sanding residue.
6. Use an air blow gun to remove all dirt from the cracks and surfaces of the vehicle.
7. Apply one medium wet coat of PPG D820 Polypropylene Primer or equivalent over all bare plastic areas.
8. Allow 10 to 15 minutes dry time before applying primer surfacer.
9. Apply two or three medium wet coats of PPG Urethane. Prime surfaces with D814 Flexible Hardener or equivalent.