Ignition Module/Passlock Sensor

REMOVAL

NOTE: Cover driver seat to protect seat trim.

IMPORTANT: If ignition module/passlock sensor is replaced, PASSLOCK relearn procedure must he performed.




1. Disable the SIR system.
2. Remove SIR coil assembly.

NOTE: Protect front of console from being damaged by steering column filler panel.




3. Remove screws and loosen screws holding data link connector near the bottom of steering column filler panel assembly. Pull steering column filler panel assembly forward and set down.




4. Disconnect cable from filler panel. Pull hood release handle forward. Feed cable under hood release handle and slide pin out. Remove steering column filler panel.




5. Remove connector position assurance (CPA) retainer and disconnect connectors from lever control switch.
6. With SIR system disabled, remove lever control switch.
7. Disconnect ignition switch electrical connector at right steering column upper support bracket.
8. On vehicles with automatic transaxles, disconnect park lock cable from ignition module.
9. Disconnect pass lock sensor connector from ignition module.




10. Remove ignition module shear bolts.
a. Use a hammer and chisel to bite into shear bolt head at a position offset from it's center.
b. Tap the chisel to rotate the bolt and loosen it.
c. Repeat until bolt is loose enough to remove.
11. Remove ignition module assembly from steering column.

INSTALLATION




1. Use new shear bolts to install ignition module assembly on steering column. Torque shear bolts until head break off.
2. Install harness clamps on steering column.
3. Connect pass lock sensor connector to ignition module.
4. On vehicles with automatic transaxles, connect park lock cable to ignition module.
5. Reconnect passlock sensor connector to ignition module.




6. Install lever control switch by fitting into bottom locating holes on ignition module.
7. Connect connectors to lever control switch. Install connector position assurance (CPA) retainers.
8. Connect ignition switch electrical connector at right steering column support bracket bolt.




9. Pull hood release handle forward. Feed cable under hood release handle and slide pin in. Connect cable to filler panel.




10. Install steering column filler panel and DLC.
11. Install and torque screws.

Torque: 3 N.m (26 in-lbs)




12. Install SIR coil assembly.
13. Enable SIR system.