Brake Transaxle Shift Interlock (BTSI) System

1. Disable the Restraint Systems.
2. Remove console.
3. Disconnect BTSI solenoid harness connector.
4. Using a screw driver, disconnect plastic retainers at solenoid base and at the park lock lever.
5. Remove solenoid from shifter assembly.

INSTALLATION
1. Install solenoid into shifter assembly. Connect plastic retainer at solenoid base and at the park lock lever.
2. Connect BTSI solenoid harness connector.
3. Verify operation. (Refer to "System Performance Test.")
4. Install console.
5. Enable the Restraint Systems.

SYSTEM PERFORMANCE TEST
- Ignition On, brake Off attempt to move shift selector out of P (Park). Lever should not be allowed out of P (Park).
- Ignition On, brake On attempt to move shift selector out of P (Park). Lever should move out of P (Park).

BTSI BYPASS
If for some reason, brake application fails to release the shifter electronically, or if service or towing requires the car to be shifted out of park without running the engine, the system can by-passed. To by-pass the system:
1. Turn the ignition key to the ACC position.
2. Apply the regular brakes.
3. Shift to N (Neutral). The vehicle may now be operated normally.