Input Shaft Roller (Quill) Bearing

- TOOLS REQUIRED
- 216916 Pad (Manual)
- SA9129T Output Shaft Roller Bearing Press Support Fixture
- SA9128T Quill Bearing Remover

REMOVAL

NOTICE: The clutch housing must be supported from underneath when pressing out the input shaft roller bearing. If the clutch housing is not supported, the housing may collapse.





1. Install support fixture SA9129T with manual transaxle adapter pad 216916 to clutch housing. After bolting to housing, tighten large center screw until adapter pad is snug against housing.





2. Place clutch housing on a press and install SA9128T bearing remover into bearing and press out bearing.