Blower Motor Switch

REMOVAL




1. Remove control head. (Refer to "HVAC Control Head" removal procedure.)
2. Remove face plate. (Refer to "Face Plate/Knobs/Buttons" removal procedure.)
3. Remove fan switch lever by prying straight off with a small flat blade screwdriver.




4. Using a flat blade screwdriver lift retaining barb on top of switch assembly and pull switch out of control head.

INSTALLATION




1. Press fan switch into control head from rear until retaining barb is seated.
2. Press fan switch lever onto fan switch until seated.
3. Install control head face plate. (Refer to "Face Plate/Knobs/Buttons" installation procedure.)




4. Install control head. (Refer to "HVAC Control Head" installation procedure.)