Assembly

WHEEL BEARING/HUB ASSEMBLY

- TOOLS REQUIRED
- J44015 Steering Linkage Installer
- J44563 Front Wheel Bearing Remover/Installer
- SA9140E Torque-to-Angle Gauge





1. Press in new bearing as shown in illustration until seated using Front Wheel Bearing Remover/Installer J44563 (or equivalent).
5 - Knuckle support tube
7 - Large driver





2. Install bearing retainer snap ring.

IMPORTANT: When performing this operation, small driver (part number 6) must be used to support bearing inner race with its small (pilot) side facing towards press, away from bearing.





3. Press in hub using part numbers:
5 - Knuckle support tube
6 - Small driver