P0647

Diagnostic Chart:

Schematic:

The A/C clutch relay is located in the Underhood Fuse Block (UHFB). The ECM controls the A/C clutch by supplying a ground to the A/C clutch relay. The ECM controls an internal driver is normally open and supplies a ground to the A/C clutch relay whenever the A/C clutch relay is commanded On. The A/C clutch relay control circuit is monitored for low and high voltage and open circuit faults. DTC P0647 will set if the ECM detects a feedback voltage above a calibrated value in the A/C clutch relay control circuit when the relay is commanded On.

DTC PARAMETERS
DTC P0647 will set if the ECM detects the A/C clutch relay control feedback voltage at the ECM is above 4.6 volts when the relay is being commanded On when:
^ Condition exists for longer than 0.5 seconds
^ Battery is between 7.5 and 15.0 volts
^ Engine is cranking/running

DTC P0647 diagnostic runs continuously with ignition On and A/C clutch relay commanded On.

P0647 is a (type D) DTC

DTC PARAMETERS
Inspect harness for chaffed wiring that may cause a short to voltage condition on circuit 459.