P0734

P0734 - INCORRECT 4TH GEAR RATIO





The Transaxle Control Module (TCM) calculates gear ratio based on the transaxle input and output speeds. The TCM compares the known gear ratio to the calculated ratio for the selected range. When the TCM detects an unknown gear ratio when 4th gear is commanded, then the DTC P0734 sets.

DTC PARAMETERS
- Engine is running
- TP angle is greater than 8%
- TFT between 21° C (70° F) and 130° C (266° F)
- Engine torque greater than 2 ft. lbs.
- Commanded ratio = 4th gear
- No engine torque default
- Time since last manual range change greater than 6 seconds
- TFP not in PARK or NEUTRAL
- Vehicle speed greater than 5 km/h (3 mph).
- No ISS, OSS, TOP or TP sensor DTCs have been set
P0734 is a (type C) DTC.

DIAGNOSTIC AIDS
- Check for improper transaxle operation per the chart on facing page.
- Check for an incorrect calibration.