P1810

P1810 - TFP Valve Position Switch Circuit (L81)
P1815 - TFP Valve Position Switch - Start In Wrong Range
P1816 - TFP Valve Position Switch - Park/neutral With Drive Ratio
P1817 - TFP Valve Position Switch - Reverse With Drive Ratio
P1818 - TFP Valve Position Switch - Drive W/o Drive Ratio





The Transaxle Fluid Pressure (TFP) switch assembly consists of six pressure switches. Five of the switches are normally open, and determine gear range selection. The sixth switch is normally closed, and detects Torque Converter Clutch (TCC) release fluid pressure. The TFP switch assembly also contains the Transaxle Fluid Temperature (TFT) sensor. These components are combined into one unit, mounted on the valve body. The TCM provides ignition voltage on the three rang signal circuits. By closing (thus grounding) one or more of the switches with fluid pressure from the manual shift valve, the TCM detects the selected gear range. When the transaxle electrical connector is disconnected and the ignition switch is On, the ground potential for three range signals from the TCM will be removed, and an illegal gear will be indicated. (Refer to TFP Switch Assembly Logic Table.)

DTC PARAMETERS
DTC P1810 will set if:
- The gear position indicated by the TFP switch assembly is illegal for 60 seconds
- Engine running
DTC P1815 will set if:
- TFP switches do not indicate PARK/NEUTRAL for 2 seconds at engine start-up
- No ISS codes
- Vehicle speed less than 3 km/h (2 mph)
DTC P1816 will set if:
TFP switches indicate PARK/NEUTRAL when the gear ratio indicates 4th gear.
DTC P1817 will set if:
TFP switches indicate REVERSE when the gear ratio indicates DRIVE.
DTC P1818 will set if:
TFP switches indicate D, 3, 2, 1 when the gear ratio indicates REVERSE.
The following conditions are for P1816-P1818:
- Engine speed is greater than 500 rpm for 5 seconds and not at fuel cutoff
- Engine torque greater than 13 Nm (10 ft. lbs.)
- TP is greater than 10% Vehicle speed is greater than 8 km/h (5 mph)
- No ISS, shift solenoid, OSS or TP sensor DTCs have been set

TFP SWITCH ASSEMBLY LOGIC TABLE (ENGINE RUNNING)





DIAGNOSTIC AIDS
A pressure regulator problem could set DTC P1810. Inspect the wiring at the TCM, the transaxle connector and the TFP valve position switch connector, and all other circuit connecting points for the following conditions:
- A bent terminal
- A backed out terminal
- A damaged terminal
- Poor terminal tension
- A chafed wire
- A broken wire inside the insulation
- Moisture intrusion
- Corrosion
When diagnosing for an intermittent short or open condition, massage the wiring harness while watching the test equipment for a change.