Radio - I/P

REMOVAL

IMPORTANT: It is not necessary to disconnect center trim plate switches.




1. Remove Center Trim Plate.
1.1 Grab trim plate at A/C vent area and pull gently to disengage attaching clips.
1.2 Tilt trim plate sideways.




2. Remove radio fasteners.
3. Pull radio out slightly to access rear of radio.
4. Disconnect electrical connector(s), antenna, and radio ground strap spade terminal from rear of radio.
5. Remove radio.

INSTALLATION




1. Connect radio ground strap spade terminal, electrical connector(s), and antenna to rear of radio.
2. Install radio by sliding into the guides on the instrument panel.
3. Install and tighten fasteners.

Torque:
Radio-to-I/P Fasteners: 2.5 N.m (22 in-lbs)




4. Install center trim plate.
4.1 Align center trim plate in place.
4.2 Snap center trim plate into I/P by gently engaging the attachment clips.