Oil Pump Removal

OIL PUMP REMOVAL

- TOOLS REQUIRED
- J42065 Crank Hub Holding Tool
- J42098 Crank Hub Torx Socket

REMOVAL
1. Disconnect negative battery cable.
2. Drain coolant.
3. Remove air cleaner assembly.





4. Remove front timing belt cover.
5. Remove timing belt.
6. Remove rear timing belt cover.
7. Remove A/C compressor and power steering pump bracket bolts.
8. Position A/C compressor and power steering pump bracket out of the way of oil pump housing and secure.
9. Remove generator lower mounting bolt.
10. Loosen upper generator mounting bolt.
11. Pivot generator out of the way and secure.
12. Remove oil pan.





13. Remove oil pickup tube.





14. Mount Crank Hub Holding Tool J42065 to crankshaft drive gear.
15. Use Crank Hub Torx Socket J42098 to remove crankshaft drive gear bolt.





16. Remove crankshaft drive gear.





17. Remove oil pump bolts.
18. Remove oil pump.
19. Remove front main oil seal and collar from oil pump.
20. Clean oil pump sealing surfaces if pump is to be reinstalled.





21. Clean engine block and upper oil pan housing sealing surfaces.
22. Ensure all old sealant, gasket material and residual oil is removed.