Head Degas Hose

HEAD DEGAS HOSE

REMOVAL





1. Disconnect negative battery cable.
2. Drain coolant.
3. Remove head degas hose to surge tank clamp and remove hose from surge tank.





4. Remove head degas hose from Underhood Fuse Block (UHFB) clamps.





5. Remove hose from harness clamp.
6. Remove wiring harness from clamp.
7. Remove wiring harness bracket to intake manifold bolt.
8. Disconnect fuel injector inline connector.
9. Remove head degas hose to head degas pipe clamp and remove head degas hose.

INSTALLATION





1. Install and position head degas hose to head degas pipe and surge tank fitting.





2. Install head degas hose to surge tank clamp at 1 o'clock position.
3. Install head degas hose to head degas pipe clamp at 2 o'clock position.





4. Install head degas hose into Underhood Fuse Block (UHFB) clamps.
5. Connect fuel injector inline connector.
6. Install wiring harness bracket to intake manifold bolt.
Torque:
Intake Manifold Bolt: 20 Nm (15 ft. lbs.)
7. Install wiring harness into harness clamp.
8. Install head degas hose into clamp.





9. Connect negative battery cable.
Torque:
Battery Terminal Bolts: 17 Nm (13 ft. lbs.)
10. Fill cooling system.
11. Use fresh water to rinse away coolant that was spilled during service.