22. Drive, Driven Sprockets and Drive Link Assemble

DRIVE, DRIVEN SPROCKETS AND DRIVE LINK ASSEMBLE





1. In order to assemble new Teflon(TM) seals onto turbine shaft, perform the following procedure:
1.1. Slide both halves of the Turbine Shaft Seal Installer/Sizer J29569 over turbine shaft.
1.2. Coat J29569-1 with transaxle fluid.
1.3. Use your fingers in order to guide new Teflon(TM) seals over J29569-1 and into seal ring grooves on turbine shaft.
1.4. Remove J29569-1 when seals are in place.
1.5. Size new Teflon(TM) seals. Use both halves of Turbine Shaft Seal Installer/Sizer J29569.
1.6. In order to properly size seals, keep J29569-2 in place for five minutes.





2. Assemble drive sprocket onto turbine shaft.
3. Retain drive sprocket with turbine shaft to drive sprocket snap ring.