C0046

DTC C0046 - LEFT REAR WHEEL SPEED CIRCUIT RANGE PERFORMANCE





Electrical Schematic









Diagnostic Charts

The wheel speed sensor produces an AC voltage whose amplitude and frequency vary, depending upon the velocity of the wheel. The ABS Control Module (EBTCM) uses this voltage signal to calculate wheel speed.

DTC PARAMETERS
DTC will set if:
^ One wheel speed changes 16 km/h (10 mph) or more in 0.01 seconds. A wheel speed sensor circuit malfunction is not set for the same wheel speed sensor. The change must occur three times with 1 second between each occurrence.

When DTC sets:
^ The ABS telltale will be On.
^ The control module will disable ABS.

DIAGNOSTIC AIDS
Possible causes for DTC to set:
^ Wheel speed sensor or circuit intermittently open or shorted.
^ Excessive sensor air gap.
^ No air gap (pole strike).
^ Low sensor output.
^ Loose sensor.
^ Worn suspension or drivetrain components.
^ Damaged tooth or teeth on speed ring.
^ Electrical noise induced on wheel speed circuit.
^ Brake switch always Off (Open).
^ Large grooves, gouges, or foreign material in speed ring.
^ A worn front hub bearing or inner axle bearing.