C0114

C0114 - PUMP MOTOR CIRCUIT OPEN










The pump motor is part of the Valve Assembly (BPMV). The system relay and pump motor driver is located in the Electronic ABS Control Module (EBTCM). The system relay supplies power to the solenoids and pump motor whenever the ignition switch is in the RUN position. The pump motor driver switches the pump motor on during ABS operation.

DTC PARAMETERS
DTC C0114 will set if:
^ System voltage is greater than 8 volts, the system relay is on and the pump is commanded off.
^ Voltage across the pump is between 1.6 and 10 volts for 2 seconds.

When the trouble code sets, ABS is disabled and the antilock telltale is turned On.
Dynamic Rear Proportioning (DRP) will only have the hold function.

DIAGNOSTIC AIDS
^ It is very important to thoroughly inspect wiring components and connectors. Failure to inspect wiring and connectors may result in misdiagnosis, causing part replacement with a reoccurring malfunction.

Possible causes for DTC C0114 to set:
^ Pump motor open.
^ Pump motor (internal) circuit open.