Engine Controls - PCM Calibration Service Information
BULLETIN NO.: 00-T-71ISSUE DATE: December, 2000
CATEGORY TYPE: Engine-23
CATEGORY: Emission Controls
CORPORATION NO.: 00-06-04-051
SUBJECT:
Service Information Regarding 2000 - 2001 Saturn S-Series Powertrain Control Module (PCM) Calibrations
MODELS AFFECTED:
2000 2001 Saturn S-Series vehicles
PURPOSE:
The chart is issued as a calibration reference for PCMs used on 2000 - 2001 Saturn S-Series vehicles.
When vehicle diagnosis leads to recalibration or replacement of a PCM, the current PCM calibration should be verified with the Tech 2 (ID Information).
The Saturn Service Stall System (SSS) will display valid calibrations for the vehicle being serviced. The calibrations listed in the chart may vary from those displayed on the SSS if updates are issued prior to this bulletin being updated.
For 1991 - 1999 Saturn S-Series calibration information, refer to Technical Information Bulletin 96-T-46B.
COLUMN HEADING DEFINITION FOR 2000 - 2001 PCMs
SERVICE P/N
This is the Saturn service P/N of the PCM which the CALIBRATION ID can be programmed into. A service PCM must be programmed with a valid CALIBRATION ID before it will function properly.
ENGINE & EMISSIONS
Engine and Emissions are used to determine proper calibration number. Refer to Service Parts Identification Label for correct emissions.
DESCRIPTION
Description identifies the purpose of calibration.
TECHNICAL BULLETIN
This is the Saturn Technical Information Bulletin number (if applicable), which details important service, diagnostic, and/or parts information specific to using the CALIBRATION ID and/or Service P/N.
CALIBRATION ID
CALIBRATION ID is displayed electronically using the Scan tool.
IMPORTANT:
The most recent CALIBRATION ID will always be shown on top of each list to supersede previous CALIBRATION ID. This number represents the PCM hardware, software and calibration combination and is also referred to as the END MODEL NUMBER.
Disclaimer