Sunroof Glass Panel Replacement

Sunroof Glass Panel Replacement

Removal Procedure






1. Power the sunroof to the vent position.
2. Remove the 6 screws attaching the sunroof glass to the module, and remove the glass.

Installation Procedure

1. Set the glass in position on the sunroof module.
2. Apply Loctite Small Screw Threadlocker 222�, or equivalent, to the sunroof glass attaching screws and install.
3. With the sunroof in the closed position, adjust the glass to 1 mm (0.040 in) below the surface of the roof at the front, and 1 mm (0.040 in) above the roof surface at the rear.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Tighten the bolts.

Tighten
Sunroof glass-to-sunroof bolts to 3 Nm (27 lb in).