Smile Joint Waterleak Repair

1. If a waterleak is detected in the "smile" joint area, clean and dry area to be repaired using compressed air and nozzle.





2. Using Kent Industries High Tech Leak Check Seam Sealer (P/N 10105), or equivalent, apply sealant inside retention channel from outside of vehicle at water leak area.

3. Verify repair by water testing after sealant has been allowed to dry according to manufacturer's recommended instructions.

4. If waterleak still persists, apply Kent Industries High Tech Leak Check Seam Sealer (P/N 10105), or equivalent, to inside retention channel from inside of vehicle at waterleak area.

5. After verifying repair, go back and perform steps 4 - 6 under "General Waterleak Testing" in this bulletin to ensure there are no additional waterleaks at the HVAC module, shock tower, or frame rail/hood hinge areas.