Operation CHARM: Car repair manuals for everyone.

P0107

Diagnostic Chart:




Schematic:




The manifold absolute pressure (MAP) sensor is a transducer that varies resistance according to changes in intake manifold pressure (vacuum). The PCM measures the signal voltage from the MAP sensor, which is a reduced value of the PCM 5 volt reference. The voltage ranges from 1-1.5 volts at idle (low pressure/high vacuum) to 4.5-4.8 volts at wide open throttle (high pressure/low vacuum). DTC P0107 sets when the MAP sensor signal voltage at the PCM is below the calibrated voltage value.

DTC PARAMETERS
DTC P0107 will set if MAP sensor voltage is less than 0.10 volts when:
^ Condition exists for longer than 6 seconds
^ Engine speed is less than 1000 rpm
^ No TP sensor DTCs have been set

OR

^ Condition exists for longer than 6 seconds
^ Engine speed is greater than 1000 rpm
^ TP angle is greater than 15%
^ No TP sensor DTCs have been set

DTC P0107 diagnostic runs continuously with engine running.

P0107 is a type B DTC

DIAGNOSTIC AIDS
To locate an intermittent problem, use Scan tool to monitor MAP sensor voltage with engine idling (high vacuum). Wiggling wires while watching for a change in MAP sensor voltage may locate the area where an open or short to ground in the wiring could lie.

The PCM supplies the MAP sensor with its own separate 5 volt reference source. There are no other external components tied to it.

IMPORTANT: Inaccurate readings will occur if resistance measurements are taken on a MAP sensor. The MAP sensor contains an internal amplifier circuit that requires applied voltage to function properly.