Body Control Systems: Service and Repair

BODY CONTROL MODULE

REMOVAL

IMPORTANT: After replacement of BCM, programming is required.




1. Open glove compartment door.
2. Remove glove compartment lamp assembly by pulling on lamp plunger.
3. Disconnect glove compartment lamp wiring harness from glove compartment lamp.




4. Remove right side I/P lower closeout panel (hush panel) retainers.
5. Pull closeout panel (hush panel) rearward to detach from forward retainers.




6. Remove right side heater outlet assembly retainer and remove outlet.




7. Remove glove compartment door.




8. Remove glove compartment bin fasteners.




9. Slowly remove glove compartment bin tilting bin downward to expose BCM residing on top of glove box.
10. Remove BCM module from glove compartment by sliding module out of attaching slots.
11. Remove BCM harness connectors.

INSTALLATION




1. Install glove compartment bin partially into opening.
2. Secure BCM to glove compartment bin slots.
3. Install BCM harness connectors.




4. Route glove box lamp wiring harness through lamp opening and connect glove compartment lamp wiring harness to glove compartment lamp.
5. Snap lamp into glove compartment bin.




6. Install glove compartment bin to I/P with fasteners.

Torque:
Glove Compartment Bin-to-I/P Fasteners: 2.5 N.m (22 in-lbs)




7. Install right side heater outlet with retainer to glove compartment bin.




8. Install right side lower I/P closeout panel (hush panel) with retainers.
9. Operate glove compartment lamp and glove compartment door to ensure proper operation.




10. Install glove compartment door with fasteners.

Torque:
Glove Compartment Door Outer Cover Fasteners: 2 N.m (18 in-lbs)