Flushing the Cooling System

FLUSHING THE COOLING SYSTEM





When the engine's cooling system becomes contaminated, it should be flushed thoroughly to remove the contaminants before the engine is seriously damaged. One source of contamination that is damaging to the engine if not corrected immediately is a cracked oil gallery. With a cracked oil gallery, oil will be forced into the cooling system while the engine is operating, and when it is stopped, coolant will leak into the lubricating system. If mixed with oil in the crankcase, this antifreeze forms a varnish which quickly immobilizes moving engine parts.
To remove such contaminants from the engine, both the cooling system and the lubrication system must be thoroughly flushed after the engine is repaired.

CAUTION: DO NOT REMOVE CAP OR OPEN COOLING SYSTEM DRAINS FROM A HOT SYSTEM. ALLOW SYSTEM TO COOL FIRST.





If the engine has had a failure resulting in the contamination of the cooling system with lubricating oil, or a substance other than a recommended antifreeze has been added, the following procedure is recommended:

1. Drain coolant.
2. Remove heater core inlet hose from thermostat outlet.
3. Remove heater core return hose from block inlet.
4. Place end of heater core return hose in a container and apply low pressure shop air 35 kPa (5 psi) to heater core inlet hose to blow coolant out of heater core.





5. Install heater core inlet hose to thermostat outlet.
6. Install clamp at 12 o'clock position.





7. Install heater return hose to thermostat outlet.
8. Install clamp at 12 o'clock position.
9. Prepare a mixture of automatic dishwasher detergent and water at the ratio of two ounces (dry measure) to 3.8 Liters (1 gallon) of water.
10. Remove the engine thermostat to permit the automatic dishwasher detergent and water mixture to circulate through the engine and the radiator.
11. Fill the cooling system with the detergent and water mixture.
12. Run the engine for 5 minutes.
13. Drain the cooling system.
14. Repeat Steps 9 through 13.
15. Fill the cooling system with clean water.
16. Let the engine run 5 minutes.
17. Drain the cooling system completely.

NOTICE: If cooling system has been contaminated by oil, replacement of the thermostat and water pump is required.

18. Install new engine thermostat.
19. Install new water pump.

IMPORTANT: The vehicle must be level when filling with coolant.

20. Fill cooling system.