6. Transaxle Oil Cooler Line Seals Installation

TRANSAXLE OIL COOLER LINE SEALS INSTALLATION

NOTICE: Hand start and tighten servo cover bolts evenly to prevent damage to servo cover bore.





1. Using a Torx socket remove the oil cooler line assembly stud from the transaxle case.
2. Place a new transaxle cooler line seal in the case bore.
3. Install oil level control valve into transaxle case.

IMPORTANT: When installing new cooler line seals, it is important to have the installing plunger of the tool centered in the transaxle's bore. If the plunger is not centered, the seal may be installed improperly and a leak would occur.

4. Install Cooler Line Seal Installer J41239 on transaxle case at the cooler line bracket bolt hole.
5. Press new transaxle cooler line seal in by tightening the seal pressing bolt on the tool until the seal bottoms Out in the case bore.
6. Repeat steps 2-5 for the second cooler line seal.