Driver or Passenger Seat Lumbar Support Replacement

Driver or Passenger Seat Lumbar Support Replacement

Removal Procedure




1. Remove the front seat assembly. Refer to Front Seat Replacement - Bucket (Front Seat Replacement - Bucket).
2. Remove the front seat back cover and pad. Refer to Driver or Passenger Seat Back Cushion Cover and Pad Replacement (Driver or Passenger Seat Back Cushion Cover and Pad Replacement).




3. Pull on the lumbar knob spacer to remove.




4. Remove the lumbar actuator cable screws from the seat frame.




5. Remove wire retainers from the lumbar assembly. Remove the lumbar assembly from the frame.

Installation Procedure




1. Install the lumbar assembly to the frame. Snap the wire retainers into place.




2. Route the lumbar actuator cable and the actuator to the seat back frame.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the lumbar actuator with the fasteners.

Tighten the fasteners to 3 Nm (27 lb in).




4. Install the lumbar knob spacer.
5. Install the seat back cover and pad. Refer to Driver or Passenger Seat Back Cushion Cover and Pad Replacement (Driver or Passenger Seat Back Cushion Cover and Pad Replacement).




6. Install the front seat assembly. Refer to Front Seat Replacement - Bucket (Front Seat Replacement - Bucket).