Window Front Guide Weatherstrip (New Style) - Rear Door

REMOVAL




1. Run window in full down position.
2. Remove door trim panel.

IMPORTANT: The old one piece weatherstrip design will work in place of the new two piece design.

3. Verify if front guide and weatherstrip is a one piece weatherstrip or the new two piece design.




4. Remove window guide and weatherstrip assembly by removing bolt and pushing guide down and out of the door.
5. Replace weatherstrip or guide as necessary.

INSTALLATION

IMPORTANT: The old one piece weatherstrip design will work in place of the new two piece design.




1. Install weatherstrip guide.




2. Install window guide and weatherstrip assembly by placing guide in door and pushing clip on guide up into down slot as shown.




3. Install guide bolt and tighten.
4. Install door trim panel.
5. Operate window to verify proper alignment and operation.