59. Oil Pan Installation

OIL PAN (UNIT REPAIR)

INSTALLATION





1. Make sure that oil pan and mounting surface on lower crankcase are free of all oil and debris.

IMPORTANT: Ensure that there is not any excessive RTV around oil pickup gallery flange area.

2. Apply a 2 mm (0.08 inch) bead of RTV (P/N 12346286) around perimeter of the oil pan and suction port opening. Do not apply more than a 2 mm (0.08 inch) bead.
3. Install oil pan.





4. Install oil pan bolts finger tight then tighten using torque sequence.
Torque:
Oil Pan-to-Block Bolts: 25 Nm (18 ft. lbs.)