Console - 2

CONSOLE

REMOVAL




1. Disable SIR system.

If Equipped:
2. Disable head curtain inflator modules.
3. Apply parking brake lever.
4. Remove power window/mirror switch or storage tray:
4.1 Exert pressure on rear with hand.
4.2 Using a small flat blade screwdriver, carefully lift switch.




4.3 Lift up and out.
4.4 Disconnect electrical connectors by locating retention tabs and disengaging connectors.




5. Adjust front seats to most forward position.
6. Remove rear console fasteners.




7. Adjust front seats to most rearward position.
8. Remove left and right lower trim panel extensions by pulling outward at dual lock locations.
9. Rotate panels outward to disengage hinges from console.




10. Remove front console fasteners.
11. Move console rearward.
12. Disengage retaining tabs and disconnect power outlet connector.




13. On automatic transaxle equipped vehicles, press and tape gear selector button in to clear shifter opening.
14. Select neutral for transaxle gear (on automatic transaxles).
15. Maneuver console beyond gear selector and parking brake by lifting rear of console.
16. Remove console from vehicle.

INSTALLATION




1. Apply park brake.
2. Adjust front seats to most rearward position.
3. Recline driver's and passenger's seat backs as far down as possible.
4. Select neutral for transaxle gear (on automatic transaxles).
5. Hold front end of console down and rear end up.
6. Position all harnesses so they can be accessed.
7. Maneuver console over gear selector lever and past brake lever.




8. Connect power outlet electrical connector.
9. On automatic transaxle equipped vehicles, remove tape from gear selector.




10. Install rear console fasteners.

Torque:
Console Rear Fasteners: 2.2 N.m (19 in-lbs)




11. Install front console fasteners.

Torque:
Console Front Fasteners: 2.2 N.m (19 in-lbs)

12. Install left and right extension panels by inserting hinges into console.
13. Rotate closed and push in at dual lock locations.




14. Connect power window switch connectors (if equipped).
15. Install power window switch or storage tray (depending on equipment).
16. Enable SIR system.




If Equipped:
17. Enable head curtain inflator modules.