Wiper Arm - (1ST Design)

REMOVAL




1. Remove wiper arm finish cap by pulling upward on cap at pivot location.




2. Remove wiper arm fastener.
3. Lift wiper arm assembly away from windshield and remove wiper arm from pivot shaft.

INSTALLATION




1. On drivers side, position wiper blade assembly between locator dot in blocked out area of windshield and bottom of dot matrix in windshield.
2. On passengers side, position wiper blade assembly at locating line in windshield.

NOTE: Use new nuts. Torque retention of old nuts may not be sufficient.

3. Install fastener.

Torque:
Wiper Arm Retaining Nuts - Front: 30 N.m (22 ft-lbs)




4. Install wiper arm finish cap.