Evaporative Emission Control Canister: Service and Repair

EVAPORATIVE EMISSION (EVAP) CANISTER REPLACEMENT

REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to Vehicle Lifting.




2. Disconnect the electrical connector from the evaporative emission (EVAP) canister vent solenoid valve.




3. Disconnect the hose connections (1, 2, 3) from the EVAP canister.




4. Remove the EVAP canister retaining bolt (1).




5. Remove the EVAP canister assembly toward the outboard side of the vehicle.
6. If the EVAP canister is to be reused, inspect the canister for loose carbon.

NOTE: The EVAP canister may have released carbon particles which caused this part to fail and may cause damage to other components. Check the EVAP canister for loose carbon before returning the vehicle to service.

INSTALLATION PROCEDURE




1. Insert the retaining tab of the EVAP canister into the slotted bracket on the vehicle underbody.




2. Install the EVAP canister retaining bolt (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the bolt to 10 N.m (89 lb in).




3. Connect the hose connections (1,2,3) to the EVAP canister.




4. Connect the electrical connector to the EVAP canister vent solenoid valve.
5. Lower the vehicle.