Accelerator Pedal: Service and Repair

ACCELERATOR CONTROLS PEDAL REPLACEMENT

REMOVAL PROCEDURE




1. Remove the accelerator pedal retaining nuts.




2. Disconnect the cruise control cable, if equipped, from the accelerator pedal assembly.




3. Disconnect the accelerator cable and remove the accelerator pedal assembly.

INSTALLATION PROCEDURE




1. Connect the accelerator cable end to the accelerator pedal assembly. Ensure that the cable end retainer is fully seated to the accelerator pedal.




2. Connect the cruise control cable, if equipped, to the accelerator pedal assembly.




3. Install the accelerator pedal assembly to the dash panel.
4. Install the accelerator pedal retaining nuts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the nuts to 10 N.m(89 lb in).

5. Ensure that the carpet is positioned correctly in relation to the accelerator pedal in full closed and wide open throttle positions.
6. Verify the complete throttle opening and closing positions by operating the accelerator pedal assembly.

IMPORTANT: The throttle should operate freely and without binding between full closed and wide open throttle positions.