Side (Sedan)

INFLATABLE RESTRAINT SIDE IMPACT SENSOR REPLACEMENT (SEDAN)

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 2 (Coupe) SIR Disabling and Enabling Zone 2 (Sedan) or to SIR Disabling and Enabling Zone 6 (Coupe) SIR Disabling and Enabling Zone 6 (Sedan).

CAUTION
- When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling Zones. Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.
- Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs.

2. Move the seat to the full forward position.
3. Remove the lower trim panel from the center pillar.
4. Remove the connector position assurance (CPA) from the harness connector on the inflatable restraint side impact sensor (SIS).
5. Disconnect the harness connector from the SIS.
6. Loosen the SIS mounting fasteners.
7. Remove the SIS from the center pillar by sliding the SIS up and out of the keyholes in the sheet metal.

INSTALLATION PROCEDURE
1. Remove any dirt, grease, or other impurities from the mounting surface.




2. Install the SIS to the center pillar by sliding the sensor fasteners into the keyhole in the sheet metal.
3. Install the SIS mounting fasteners.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the fasteners to 7.5 N.m (66 lb in).

4. Install the harness connector to the SIS.
5. Install the CPA to the SIS harness connector.
6. Install the lower trim panel to the center pillar.
7. Move the seat to the original position.
8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2 (Coupe) SIR Disabling and Enabling Zone 2 (Sedan) or to SIR Disabling and Enabling Zone 6 (Coupe) SIR Disabling and Enabling Zone 6 (Sedan).