Multifunction, Turn Signal Switch

Multifunction, Turn Signal Switch Replacement

Removal Procedure





1. Remove the steering column trim covers.
2. Disconnect the Multifunction turn signal switch harness connector.
3. Remove the multifunction turn signal switch retaining screws.
4. Remove the multifunction turn signal switch from the steering column.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the multifunction turn signal switch to the steering column.
- Tighten the Multifunction turn signal switch screws to 2 Nm (17 inch lbs.).
2. Connect the multifunction turn signal switch harness connector.
3. Install the steering column trim covers.