89. Second Coast Clutch Assemble

Second Coast Clutch Assemble
^ Tools Required
- J 28585 Snap Ring Remover
- J 23327CIutch Spring Compressor
- J 41236 Coast Clutch Spring Compressor
- J 45164 Spring Compressor Bridge





1. Apply automatic transmission fluid to the new second coast clutch piston seals.
2. Install the new inner seal (221) and the outer seal (223) onto the second coast clutch piston (222).
3. Apply automatic transmission fluid to the inner surfaces of the fluid pump stator shaft assembly.
4. Press the second coast clutch piston (222) into the fluid pump stator shaft assembly.





5. Install the second coast clutch spring assembly (224) making sure to index the springs into the notches in the second coast clutch
piston.





6. Place the J 21420-2 (1) and J 23327-2 (3), which are part of J 23327, and J 41236 (2) on the second coast clutch spring (224), and compress the springs.
7. Using snap ring pliers, install the second coast clutch spring retaining ring (225) into the groove of the fluid pump stator shaft assembly.





Important: Make sure that you have the correct number of clutch plates, and that they are in the correct order.

8. Install a steel plate (227) then a fiber plate (228). Repeat this sequence until all 6 plates have been installed.
9. Install the second coast clutch backing plate (229).





10. Using J 45164 (2), J 21420-2 (4) and J 23327-2 (1), which are part of J 23327, compress the second clutch spring.
11. Using J28585 (3), install the second coast clutch backing plate retaining ring (230) into the groove of the fluid pump stator shaft assembly.