39. Torque Converter and Differential Housing Installation

Torque Converter and Differential Housing Installation

Tools Required
^ J36850 Assembly Lubricant





1. Apply J36850 to the prong-side mating surface of a drive sprocket thrust washer.
2. Install the thrust washer onto the torque converter and differential housing assembly.





3. Notice: Use extreme care when applying sealant. Ensure the bead of sealant does not exceed 1 - 2 mm (0.04 - 0.08 inch). Excess sealant inside the transmission may cause restrictions resulting in various performance and noise complaints.

Important: Anaerobic sealant GM P/N 22722716 is the only authorized sealant that should be applied to the mating surfaces.

Important: Ensure the bead of sealant is centered on the mating surface between the bolt holes, and on the inside mating surface around the bolt holes.

Apply a 1 - 2 mm (0.04 - 0.08 inch) bead of sealant GM P/N 22722716 to the mating surface of the transmission case assembly.





4. Carefully install the torque converter and differential housing assembly on the transmission case assembly.





5. Notice: Refer to Fastener Notice in Service Precautions.

Secure the torque converter and differential housing assembly to the transmission case assembly with 22 NEW bolts.
Tighten the bolts to 28 Nm (21 ft. lbs.) in the sequence shown.