Rear Side Door Window Replacement

Window Replacement - Rear Door

Removal Procedure

1. Remove the door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair
2. Remove enough of the door water deflector in order to access the door window to regulator bolts. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .




3. Connect the power window switch and open the rear door window until you can access the window bolts through the inner access holes.
4. Remove the door window frame applique. Refer to Door Frame Applique Replacement - Front () or to Door Frame Applique Replacement - Rear () .
5. Remove the outer belt seal. Refer to Sealing Strip Replacement - Rear Door Window Belt Outer (Rear Door Window Belt Outer Sealing Strip Replacement) .
6. Disengage the window from the run channels.
7. Remove the window to sash bolts.
8. Remove the window from the door.



Installation Procedure





1. Install the rear side door window in the door.
2. Engage the window in the run channels.
3. Install the outer belt seal. Refer to Sealing Strip Replacement - Rear Door Window Belt Outer (Rear Door Window Belt Outer Sealing Strip Replacement) .
4. Install the door window frame applique. Refer to Door Frame Applique Replacement - Front () or to Door Frame Applique Replacement - Rear () .
5. Slide the window to the full up position and tape the window in place.
6. Connect the power window switch and move the window regulator to gain access to the window bolts through the inner panel.
7. Lower the window and attach the window to the regulator.

Notice: Refer to Fastener Notice in Cautions and Notices.

8. Install the bolts.

Tighten the bolts to 10 N.m (89 lb in).

9. Install the door water deflector. Refer to Water Deflector Replacement - Rear Door (Service and Repair) .
10. Install the door trim panel. Refer to Trim Panel Replacement - Side Rear Door Service and Repair