Fuel Injector Assembly

REMOVAL

CAUTION: DO NOT ALLOW SMOKING OR THE USE OF OPEN FLAMES IN THE AREA WHERE WORK ON THE FUEL SYSTEM IS TAKING PLACE. ANYTIME THE FUEL SYSTEM IS BEING WORKED ON, DISCONNECT THE NEGATIVE BATTERY CABLE, EXCEPT FOR THOSE TESTS WHERE BATTERY VOLTAGE IS REQUIRED.

NOTE: Use care in removing fuel injectors to prevent damage to electrical connector pins on fuel injector and nozzle. The fuel injector is serviced as a complete assembly only. Since it is an electrical component, it should not be immersed in any type of cleaner. Support fuel rail to avoid damaging other components while removing fuel injector.

1. Remove fuel rail. (Refer to "Fuel Rail Removal" procedure.)




2. Slide fuel injector retainer clip off fuel injector.

IMPORTANT: Clean the fuel rail prior to removing the fuel injector.

3. Remove port fuel injector assembly and plug the fuel injector port.

IMPORTANT: Any time the fuel system is opened for service, the O-ring seals used with related components must be replaced.

4. Remove fuel injector O-rings and discard.

INSTALLATION




1. Lubricate new fuel injector O-ring seals with clean engine oil and install on fuel injector assembly.
2. Install clip onto injector prior to installing injector to fuel rail.
3. Install port fuel injector assembly into fuel rail, with the fuel injector electrical connector facing upward.

IMPORTANT: Press injector into fuel rail until it "clicks" into the retainer clip.

4. Install fuel rail assembly.