40. Oil Pump Assemble

Oil Pump Assemble






1. Lubricate all oil pump parts with engine oil.
2. Install the inner gear into the outer gear.

Important: If gears are improperly installed in the front cover, the gerotor cover will not bolt on.

3. Install the gears together into the front cover with the hub of the center gear facing the front cover.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the oil pump gerotor cover and bolts.

Tighten
Tighten the oil pump gerotor bolts to 6 Nm (53 lb in).






5. Install the pressure relief valve piston.
6. Install the pressure relief valve spring.

Tighten
Tighten the pressure relief valve plug to 40 Nm (30 lb ft).