64. Camshaft Cover Installation

Camshaft Cover Installation






1. Install NEW camshaft cover grommets and camshaft cover bolts if they are serviced with the grommets.
2. Assemble the camshaft cover and gasket. Ensure that the gasket is located in the retaining groove in the camshaft cover.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the cover on the cylinder head and hand start the bolts.

Tighten
Tighten the camshaft cover bolts to 8 Nm (71 lb in).






4. Install the spark plugs.

Tighten
Tighten the spark plugs to 20 Nm (15 lb ft).






5. Install the ignition coil and module assembly bolts to the cam cover.
6. Install the ignition coil and module assembly bolts.

Tighten
Tighten the ignition coil and module assembly bolts to 8 Nm (71 lb in).






7. Install the ignition coil cover.
8. Install the ignition coil cover bolts.

Tighten
Tighten the bolts to 8 Nm (71 lb in).






9. Install the lift hook.
10. Install the lift hook bolts.

Tighten
Tighten the bolts to 22 Nm (16 lb ft).






11. Install the camshaft position sensor.
12. Install the camshaft position sensor bolt.

Tighten
Tighten the bolt to 8 Nm (71 lb in).






13. Install the power steering blockout plate.
14. Install the power steering blockout plate studs.

Tighten
Tighten the power steering blockout plate bolts to 25 Nm (18 lb ft).