Battery Tray: Service and Repair

Battery Tray Replacement

Removal Procedure
Caution: Refer toApproved Equipment for Collision Repair Caution in Cautions and Notices.

1. Disable the SIR system. Refer to SIR Disabling and Enabling Zones in SIR.
2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.

Important: This panel is replaced at factory seams.


3. Remove all related panels and components.
4. Repair as much of the damaged area as possible. Refer to Dimensions - Body () .
5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair () in Paint and Coatings.

Important: Note the number and location of the factory welds for installation of the battery tray.






6. Locate and drill out all the necessary factory welds.
7. Remove the battery tray.



Installation Procedure






Important: If the location of the original plug weld holes can not be determined, space the plug weld holes every 40 mm (1 1/2 in) apart.


1. Drill 8 mm (5/16 in) plug weld holes in the service part as necessary in the locations noted from the original panel.
2. Prepare all mating surfaces for welding as necessary.
3. Apply 3M Weld-Thru Coating P/N 05916 or equivalent to all mating surfaces.
4. Position the battery tray to the vehicle. Clamp the battery tray in place.
5. Plug weld accordingly.
6. Clean and prepare all of the welded surfaces.
7. Install all of the related panels and components.
8. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair () in Paint and Coatings.
9. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems (Basecoat/Clearcoat Paint Systems) in Paint and Coatings.
10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
11. Enable the SIR system. Refer to SIR Disabling and Enabling Zones in SIR.