Mode Control Cable Replacement

MODE CONTROL CABLE REPLACEMENT

REMOVAL PROCEDURE




1. Pull out on the accessory trim plate in order to release the retaining fasteners.




2. Disconnect the accessory trim plate electrical connector(s).




3. Remove the screws from the radio and pull the radio out.




4. Disconnect the radio electrical connectors and remove the radio.




5. Disconnect the mode and temperature cables from the HVAC control assembly.

IMPORTANT: Do not bend the mode and temperature cables.




6. Disconnect the HVAC control assembly electrical connectors.




7. Remove the HVAC control assembly screws and remove the HVAC control assembly.
8. If equipped with cruise control, remove the cruise control module from the brake pedal bracket.




9. Remove the mode cable screw and remove the mode cable.

IMPORTANT: Do not bend the mode cable.

INSTALLATION PROCEDURE




1. Install the mode cable. Make certain that the cable is properly seated in the notch in the HVAC module.

IMPORTANT: Do not bend the mode cable.

2. Install the mode cable screw.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screw to 2 N.m (18 lb in).

3. If equipped with cruise control, install the cruise control module to the brake pedal bracket.




4. Install the HVAC control assembly.
5. Install the HVAC control assembly screws.

Tighten
Tighten the screws to 2.5 N.m (22 lb in).




6. Connect the mode and temperature cables to the HVAC control assembly.

IMPORTANT Do not bend the mode and temperature cables.




7. Connect the HVAC control assembly electrical connectors.




8. Place the radio in the vehicle and connect the radio electrical connectors.




9. Push the radio into position.
10. Install the radio screws.

Tighten
Tighten the screws to 2.5 N.m (22 lb in).




11. Connect the accessory trim plate electrical connector(s).




12. Align the retaining fasteners with the I/P.
13. Push on the outer edge of the accessory trim plate in order to secure the retaining fasteners.