Output Shaft Speed Sensor Replacement
Output Shaft Speed Sensor ReplacementRemoval Procedure
1. Disconnect the wiring harness from the output speed sensor.
Important: Do not damage the output speed sensor or transaxle case.
2. Remove the output speed sensor bolt/screw (61).
3. Remove the output shaft speed sensor (62) and the 0-ring (63).
4. Inspect the output speed sensor for damage.
Installation Procedure
1. Apply automatic transmission fluid to the new output speed sensor 0-ring seal (63).
2. Install the new output speed sensor 0-ring seal (63) onto the output speed sensor (62).
3. Install the output speed sensor (62) into the transmission case assembly.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the output speed sensor bolt (61).
^ Tighten the output speed sensor bolt to 4.5 Nm (40 inch lbs.).