Wiper Switch: Service and Repair

WIPERS/WASHER SWITCH REPLACEMENT

REMOVAL PROCEDURE
1. Remove the steering column trim covers.
2. Disconnect the wipers/washer switch harness connector.




3. Remove the wipers/washer signal switch retaining screws.
4. Remove the wipers/washer signal switch from the steering column.

INSTALLATION PROCEDURE




1. Install the wipers/washer signal switch to the steering column.

NOTE: Refer to Fastener Note in Service Precautions.

Tighten the wipers/washer signal switch screws to 2 N.m (17 lb in).

2. Connect the wipers/washer switch harness connector.
3. Install the steering column trim covers.