Wheel Speed Sensor Replacement - Rear

Wheel Speed Sensor Replacement - Rear

Removal Procedure

Important: The rear wheel speed sensors and rings are integral with the hub and bearing assemblies.

If a speed sensor or a ring needs replacement, replace the entire hub and bearing assembly.

1. Raise and support the vehicle on a suitable hoist. Refer to Vehicle Lifting.
2. Remove the rear tire and wheel assembly.





3. Disconnect the electrical connector from the rear wheel speed sensor.
4. Remove the hub and bearing assembly.

Installation Procedure
1. Install the hub and bearing assembly to the vehicle.





2. Connect the electrical connector to the rear wheel speed sensor.
3. Install the wheel and tire assembly.
4. Lower the vehicle.
5. Turn the ignition switch to the ON position, with the engine OFF.
6. Perform the Diagnostic System Check - ABS.