60. Oil Pan Installation

Oil Pan Installation





1. Make sure that the oil pan and mounting surface on the lower crankcase are free of all oil and debris.
2. Apply a 2 mm bead of RTV P/N 21019581, around the perimeter of the oil pan and the oil suction port opening. Do not over apply the RTV. More than a 2 mm bead is not required.





3. Install the oil pan.






Notice: Refer to Fastener Notice in Service Precautions

4. Install the oil pan bolts hand tight.
^ Tighten the oil pan bolts to 25 Nm (18 ft. lbs.) in sequence.