Throttle Position Sensor: Service and Repair
THROTTLE POSITION (TP) SENSOR REPLACEMENTREMOVAL PROCEDURE
NOTE: The throttle position (TP) sensor is an electrical component, and must NOT be soaked in any liquid solvent or damage may occur.
1. Turn the ignition OFF.
2. Disconnect the TP sensor harness connector.
3. Remove the TP sensor attachment screws and remove the TP sensor.
INSTALLATION PROCEDURE
1. Clean the O-ring sealing surface and the throttle shaft. Make sure the O-ring is seated in the TP sensor.
2. With the throttle plate closed, install the TP sensor over the throttle shaft.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Apply LOCTITE 242(R) Threadlocker to the threads of the TP sensor attachment screws and install the screws.
Tighten the throttle position sensor screws to 2 N.m (18 lb in).
4. Connect the TP sensor harness connector. Push in the connector until a click is heard and pull back to confirm a positive engagement.